Installation Procedure; Direct Wall Mounting Of The Regen Supply Module; Din Rail Mounting (Frames A And B Only) Of The Regen Supply Module - ABB ACSM1 Hardware Manual

34

Installation procedure

Direct wall mounting of the regen supply module

1. Mark the locations for the four holes. The mounting points are shown in
Dimension
2. Fix the screws or bolts to the marked locations.
3. Position the regen supply module onto the screws on the wall. Note: Only lift the
regen supply module by its chassis.
4. Tighten the screws.

DIN rail mounting (Frames A and B only) of the regen supply module

1. Click the regen supply module to the rail as shown in Figure a below. To detach
the regen supply module, press the release lever on top of the module as shown
in Figure b.
2. Fasten the lower edge of the regen supply module to the mounting base through
the two fastening points.
a
Mechanical installation
drawings.
1
2
b