Installation Of The Wfu-Xx Regen Filter Module; Braking Resistor Installation - ABB ACSM1 Hardware Manual
Regen supply modules
Hide thumbs
Also See for ACSM1:
- Manual (510 pages) ,
- Firmware manual (448 pages) ,
- Hardware manual (112 pages)
Table of Contents
Advertisement
36
Installation of the WFU-xx regen filter module
1. Mark the locations for the four holes.
2. Fix the screws or bolts to the marked locations.
3. Position the filter module onto the screws on the wall. Note: Only lift the filter
module by its chassis.
4. Tighten the screws.
Braking resistor installation
See the chapter
Mechanical installation
Resistor braking
on page 83.
Advertisement
Table of Contents
