Function Selection - Hitachi CIW03-H Installation & Maintenance Manual

6. Function Selection

Function Selection is set from Installation Menu.
Step1. Select "Installation Menu" and press "OK" .
Step2. Select "Function Selection "and press "OK".
Step3. Press "OK".
Step4. Press " ", " ", " ", or " " to select the indoor unit to be set and
press "OK".
This screen is not displayed when only one indoor unit is
connected to the wired remote controller. (The screen in Step5
is shown.)
Step5. Press "
" or " "
→It changes in the order of "b-J" ↔ "K-P" ↔ "q-S" ↔ " ".
Step6. Press " ", " ", " ", or " " to select the item to set from the
list area. Press "
value.
After selecting the setting value, press " " to return to the
setting item selection mode.
To return to Step 5, press " " in the setting item selection
mode.
Step7. To confirm the setting, press " " in the tab selection mode.
Step8. Select "Yes" and press "OK" to confirm the setting and return
to Step2.
Select "No" and press "OK" to discard the settings and return
to Step2.
Press " "to return to Step5.
A16381TMF2
to select the type tab and press "OK".
" and press " to change the setting
" or " "
6. Function Selection
Service & Installation
Service Menu
Installation Menu
Check Menu
Select
OK
Installation Menu
Test Run
Function Selection
Thermistor Selection
Input/Output
Thermistor Calibration in Controller
OK Select
Installation Menu
Test Run
The function descriptions are for
reference only. Refer to technical
Function Selection
documents of unit for details.
Input/Output
OK
Thermistor Selection
OK
Thermistor Calibration in Controller
OK OK Enter Select
Function Selection
ALL
00-00
00-01
00-02
Select
OK
Indoor unit number
(Refrigerant system number
—Address number)
Function Selection : 00-00
b1: Set heating temperature compensation
01:Tset+0 o C( no compensation)
b-J
b1 01 b7 00 bd 00
K-P
b2 00 b8 00 bE 00
b3 00 b9 00 C1 00
q-S
b4 00 bA 00 C2 00
b5 00 bb 00 C3 00
b6 00 bC 00 C4 00
OK Select
Type tab List area
Function Selection : 00-00
Cancellation of Heating Temp Compensation due to Uneven Heat Load
01:Standard(Set Temp. +7oF(+4oC))
Confirm function selection setting?
b1 01 b7 00 bd 00
b-J b2 00 b8 00 bE 00
b3 00 b9 00 C1 00
K-P
b4 00 Yes bA 00 C2 00 No
q-S
b5 00 bb 00 C3 00
b6 00 bC 00 C4 00
Select
OK OK Long Press either selection dialog
(Mon) 16:30
Back
(Mon) 16:30
Back
Back Back
Back
C5 00
C6 00
C7 00
C8 00
C9 00
CA 00
Back
C5 00
C6 00
C7 00
C8 00
C9 00
CA 00
Back Back
9