Table of Contents
Advertisement
(2) Attach the controller to the holding bracket and connect the cable as follows.
1. In Case of Exposing the Controller Cable
A. Secure the holding bracket
onto the wall with screws
(accessory)
2. When Using Junction Box
a. Prepare the optional field-supplied Implanted Junction Box.
b. Feed the cable through the conduit tubing in the wall.
c. Cut away the insulation at the end of the cable and clamp the M3 solderless terminals (field-supplied).
(3) Attach the controller body to the mounted holding bracket. Be careful not to pinch the cable when attaching
it.
(4) After installation, remove the protective film from the LCD screen.
A16381TMF2
Cable
Band Stopper
(Field-Supplied)
Optional M-size
Junction Box
M4 Screws
(Field-Supplied)
Draw-out Hole
D. Attach the stopper (plastic band)
to the cable at the inside of
the draw-out hole.
B. Peel away the insulation
B
A
at the end of the cable
and clamp the M3 (field-
supplied) solderless
terminals .
C. Feed the cable with its
sheath peeled through
the groove.
Optional S-size
Junction Box
B
A
Connect the terminals.
2. Installation Work
Remove the
protective film.
5
Advertisement
Table of Contents
