Table of Contents
Advertisement
8. Main Remote Setting
•
Concerning main and sub controllers, the range of settings may differ for the functions shown below.
Power Saving Details Setting
Outdoor Unit
Capacity Control
Indoor Unit
Rotation Control
Intermittent Control
Night Quiet Operation
Power Savings Schedule
Night Quiet Operation Schedule
Power Up Setting
Autoboost
○
×
: Available
: Not Available
● Changing from the sub controller to the main controller.
Step1. Select "Installation Menu" on the Service & Installation screen by pressing " " and press "OK".
Step2. Select "Main Remote Setting" by pressing " " or " " and press "OK".
Step3. Select "Yes" and press "OK" to change to the main remote.
"Change to main remote" is displayed on the screen.
Select "Cancel" to return to Step2.
*After the change is completed, the Power Savings Mode
will change to "No Setting". After the following functions
initialized, reset the setting for the "Power Savings Setting",
"Power Saving/Night Quiet Schedule", "Night Quiet Operation",
"Priority Setting" and "Power Up Setting" .
Step4. When the change to main remote control is completed, the "Reconfigure each setting" screen is
displayed.
Step5. Press "OK" on the confirmation screen to return to Installation Menu.
NOTES:
•
When using two controllers, only the primary controller can be set as the main controller. In cases where
two controllers are both sub controllers, the "Main Remote Setting" is only accessible from the primary
controller.
•
In cases where the primary controller is a "Main Controller" and the secondary controller is a "Sub
Controller", when the primary controller and the secondary controller are changed by the function selection,
Main and Sub controllers will also be switched simultaneously.
•
If the sub controller is displayed, the main remote controller may not function normally. Please verify the
cable connection.
•
If a remote control group is operating with multiple refrigerant systems, the ECO function may not operate
normally.
24
Table D. Relation between Main/Sub Controller and Setting Range
Function
Details Setting
Power Savings Level Switch
Details Setting
ON/OFF
Details Setting
Power Savings Level Switch
Outdoor Capacity Control
Intermittent Control
Main
Sub
○
×
○
×
○
×
○
×
○
○
○
○
○
○
○
×
○
×
○
○
○
×
○
×
○
○
Installation Menu
Address Initialization
Change to main remote even if
Setting Initialization
each settings is initialized?
Main Remote Setting
Yes
Cancel
Priority Setting
Cancel preheating control
Enter
Select
OK
OK
(Mon) 16:30
Back
Back
A16381TMF2
Advertisement
Table of Contents
