Table of Contents
Advertisement
Service
Menu Item
H
OURS
C
OUNTS
T
RACTION CALIBRATION
Diagnostics
Menu Item
B
ATTERY
CAN
M
OTOR CONTROL
Settings
Menu Item
L
ANGUAGE
B
ACKLIGHT
C
ONTRAST
P
M
ROTECTED
ENUS
Description
Lists the total number of
hours that the key, motors,
and attachment modes have
been on and the hours
that the traction controls
and hydraulics have been
engaged.
Lists the number of hydraulic
motor starts, charge cycles,
and low battery alerts.
Calibrates the traction control.
Description
Indicates the inputs and
outputs for the battery. Inputs
include the current battery
voltage; outputs include the
battery current and percentage
state of charge.
Indicates the status, health,
and utilization of the CAN bus.
Indicates the inputs and
outputs for the motor control.
Inputs include key run, key
start, parking brake, auxiliary,
raise/lower, bucket curl,
backhoe seat, logic voltage,
motor voltage, DC current;
use these to check input
feedback on the machine.
Outputs include motor speed
(in rpm), phase current, motor
torque, controller temperature,
motor temperature,
electromechanical brake,
contactor, auxiliary, 5 and 12
V supply, and drivers.
Description
Controls the language used
on the InfoCenter.
Controls the brightness of the
LCD display
Controls the contrast of the
LCD display.
Allows you to access
protected menus by inputting
a passcode.
About
Menu Item
M
ODEL
S
ERIAL
S/W R
EV
M
C
SW
OTOR
TRL
B
SW
ATTERY
Specifications
Note:
Specifications and design are subject to
change without notice.
Width
Length
Height
Weight (without attachment)
Rated operating capacity—with 74.8
kg (165 lb) operator and the standard
bucket
Tipping capacity—with 74.8 kg (165 lb)
operator and the standard bucket
Wheelbase
Dump height (with standard bucket)
Reach—fully raised (with standard
bucket)
Height to hinge pin (narrow bucket in
standard position)
Average ground pressure (with empty
standard bucket)
Average ground pressure (at rated
operating capacity)
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
15
Description
Lists the model number of the
machine
Lists the serial number of the
machine
Lists the software revision of
the master controller.
Lists the software revision of
the motor control.
Lists the software revision of
the battery.
76 cm (30 inches)
168 cm (66 inches)
138 cm (54 inches)
1062 kg (2342 lb)
234 kg (515 lb)
567 kg (1251 lb)
71 cm (28 inches)
160 cm (63 inches)
55 cm (22-1/2
206 cm (81 inches)
579 kPa (84 psi)
620 kPa (90 psi)
www.Toro.com
for a list of all
inches)
Advertisement
Table of Contents
