Table of Contents
Advertisement
Accessing Internal
Components
WARNING
Opening or removing covers, hoods, and
screens while the machine is running could
allow you to contact moving parts, seriously
injuring you.
Before opening any of the covers, hoods, and
screens, shut off the machine, remove the key
from the key switch, and allow the machine
to cool.
WARNING
The rotating fan can cause personal injury.
• Do not operate the machine without guards
in place.
• Keep your fingers, hands, and clothing
clear of the rotating fan.
• Shut off the machine and remove the key
before performing maintenance.
Removing the Hood
1.
Park the machine on a level surface.
2.
Shut off the machine, remove the key, and wait
for moving parts to stop.
3.
Remove the 4 bolts (3/8 x 1-1/2 inches) securing
the hood.
Figure 27
4.
Pull the hood off the machine.
Reverse the procedure to install the hood.
Removing the Lower Front
Cover
1.
Park the machine on a level surface.
2.
Raise the loader arms and install the cylinder
locks.
Note:
If you cannot raise the loader arms using
the machine power, pull the loader-arm lever
rearward and use a hoist to lift the loader arms
at their lift points.
3.
Shut off the machine, remove the key, and wait
for moving parts to stop.
4.
Remove the hood.
5.
Remove the 2 bolts (3/8 x 1 inch) securing the
cover.
6.
Remove the cover.
Reverse the procedure to install the cover.
g387431
28
Figure 28
g387443
Advertisement
Table of Contents
