54 Mechanical installation
Frame Size
R0
R1
R2
R3
R4
R5
R6
R7
R8
R8
Check the installation site according to the requirements below:
•
The installation site is sufficiently ventilated or cooled to remove heat from
the drives. See section
•
The operation conditions of the drive meet the specifications given in section
Ambient conditions (page
•
The wall is as close to vertical as possible, of non-flammable material and
strong enough to carry the weight of the drive, see section
breakers (page
•
The floor/material below the installation is non-flammable.
•
There is enough free space above and below the drive to enable cooling air
flow, service and maintenance. See the required free space tables for each of
the different mounting alignments in
(or
Dimensions, weights and free space requirements (page
Required tools
To install the drive mechanically, you need the following tools:
•
Drill with suitable bits.
•
Screwdriver and/or wrench with a set of suitable bits (as appropriate for the
installation hardware used).
•
Tape measure, if you are not using the provided mounting template.
Vertical installation side by side -
Above (a)
mm
in
75
3
75
3
75
3
200
7.9
200
7.9
200
7.9
200
7.9
200
7.9
200
7.9
200
7.9
Thermal losses, cooling data and noise (page
160).
147).
Free space
Below (b)
mm
in
75
3
75
3
75
3
200
7.9
200
7.9
200
11.8
300
11.8
300
11.8
300
11.8
300
11.8
Checking the installation site (page 53)
Between (c)
mm
in
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
149).
Circuit
148)).