Epson AcuLaser CX37DN Series User Manual page 152

1. With the main screen (Scan mode) or Can Use AddressBook displayed, press the Addressbook
key four times so that ADDRESS BOOK appears.
2. Press the u or d key to select LDAP SEARCH, and then press the Select key.
3. Press the u or d key to select NAME or E-MAIL, and then press the Select key.
Note:
To search registered names, select NAME. To search e-mail addresses, select E-MAIL.
4. Use the keypad to type in the search keyword (maximum of 10 characters), and then press the
Select key.
The search begins, and the search results appear after a while. If no data matches the search
keyword, NOT FOUND appears for about two seconds.
Note:
❏ For details on entering/editing text, refer to Facsimile User's Guide.
❏ Text starting with the first character of the maximum 10 characters is searched for. Text will not
be found if the search keyword is in the middle of a word.
5. Press the u or d key to select the desired data, and then press the Select key.
Note:
❏ To check the found information, press the r key.
❏ An e-mail address exceeding 64 characters cannot be specified. If such an e-mail address is
specified, ADDRESS IS TOO LONG appears for about two seconds, and then the screen for
specifying the destination address appears.
❏ To narrow down the search results, press the Back key, and then perform step 4 again.
6. Press the Select key again.
7. Press the u or d key to select FINISH, and then press the Select key.
Note:
To add an additional e-mail address, select ADD in step 7, and then specify the destination. To edit the
specified e-mail address, select CHECK/EDIT in step 7, and then continue with step 2 of "Editing a
Specified Destination Address". To delete a specified e-mail address, select CHECK/EDIT in step 7,
and then continue with step 2 of "Deleting a Specified Destination Address". The address cannot be
edited.
Epson AcuLaser CX37 Series Printer/Copier/Scanner User's Guide
Using the Scanner 152