Epson AcuLaser CX37DN Series User Manual page 233

This message...
NOT E-MAIL ADDRESS
NOT INSTALLED P/U
CHECK x
NOT INSTALLED TONER
CHECK x
NOT REGISTERED
OUTPUT TRAY FULL
REMOVE PAPER
OVER SEARCH TIME
P/U END
REPLACE x
P/U End x
P/U Life (x)
P/U Low x
PAGE NO. NOT MATCH
(PRESS ANY KEY)
PAPER EMPTY
LOAD PAPER (xxx)
Epson AcuLaser CX37 Series
means...
When the destination for the
scan data was specified, a fax
number registered in the favorite
list or as a speed dial destination
or group dial destination has
been selected.
The indicated photoconductor
unit is not installed.
The indicated toner cartridge is
not installed.
No speed dial destination or
group dial destination is
registered.
The output tray is full of paper.
Communication with the LDAP
server has timed out.
The time to replace the indicated
photoconductor unit has been
reached.
The time to replace the indicated
photoconductor unit has been
reached.
The time to replace the indicated
photoconductor unit has been
reached.
The indicated photoconductor
unit is low and should be
replaced within 200 pages at 5%
coverage of Letter/A4 paper.
The front and back sides of the
document pages for 2-SIDE &
2-SIDE or 2-SIDE & 1-SIDE do
not match.
The indicated paper tray has run
out of paper.
Printer/Copier/Scanner User's Guide
Do this...
Directly type in the destination for
the scan data, or specify an e-mail
address registered in the favorite list
or as a speed dial destination or
group dial destination.
Install the indicated photoconductor
unit.
Install the indicated toner cartridge.
Directly type in the destination
address for the scan data, or register a
speed dial destination or group dial
destination and try specifying the
destination address again.
Remove all paper from the output
tray.
Establish a connection with the LDAP
server again.
Replace the indicated
photoconductor unit.
Replace the indicated
photoconductor unit.
Replace the indicated
photoconductor unit.
Prepare the indicated
photoconductor unit.
Press any key to cancel the job.
Load media into the indicated tray.
Troubleshooting 233