Disabling And Then Transferring The System Options - Canon imageRUNNER ADVANCE System V3.13 Service Manual

Disabling and then Transferring the System Options

When the device needs to be replaced as a service work, the system options on the device need to be transferred. This work
involves operation in service mode and is therefore supposed to be performed by service technicians.
The procedure is shown below.
1. Access the following service mode.
• (LEVEL 2) COPIER > Option > LCNS-TR
2. Select [ST-XXXX] of the option to be disabled.
3. Change the setting value from 1 to 0.
4. When the license is disabled, an invalidation certificate key (4 digits x 6) is displayed in the [TR-XXXX] column. Write
down the key.
5. If there are multiple licenses, repeat steps 2 to 4.
6. Complete setup of the transfer destination device, and check the serial number of the device.
7. Inform the Support Dept. of the sales company of the invalidation certificate key necessary for transfer of the license,
the serial number of the transfer source device, and the serial number of the transfer destination device, and request
the Support Dept. to issue a transfer license for the transfer destination device.
8. Using the obtained transfer license, activate the system option on the transfer destination device.
9. Start the function and check that the system option has been transferred properly.
5. Management of System Options
86