Application Installation Procedure - Canon imageRUNNER ADVANCE System V3.13 Service Manual

■ Network Port Change Procedure
The default port of the HTTP server used for MEAP and MEAP applications to provide the servlet function is 8000, and the HTTPS
server's default port is 8443. In the case that these ports have already used by the customer who is to introduce this application,
the MEAP application cannot use the HTTP (or HTTPS) server(s).
By changing the following ports to use, however, the MEAP application can be used as well as the existing system.
The procedure to set the HTTP/HTTPS server port is indicated below.
1. Set the port numbers in the following service mode.
To set the HTTP server port
• (LEVEL 2) COPIER > Option > NETWORK > MEAP-PN
To set the HTTPS (TLS) server port
• (LEVEL 2) COPIER > Option > NETWORK > MEAP-TLS
NOTE:
A port number can be any integer from 0 to 65535. To avoid port numbers that are frequently used, do not use any integer from
0 to 1023.
Server
HTTP Server
HTTPS Server
NOTE:
• If Print Server is connected, do not specify port 8080.
If port 8080 is specified, it is not possible to access the remote UI of the device where the MEAP authentication application
is running. (Port 8080 is reserved to allow the PS Print Server Unit to redirect to the device.)
• As for port on HTTPS server, it only applies to the device that supports TLS function.
2. Restart the device if the port number is set.

Application Installation Procedure

■ Installation Procedure Using SMS
For the installation of MEAP applications using SMS, refer to the following section of the User's Guide found at the following URL.
• https://oip.manual.canon/
Top > Appendix > MEAP > Installing MEAP Applications
■ Installation Procedure Using the Updater
To install a MEAP application using the Updater, the following preparations are required.
• License access number required for installing the MEAP application
1. From the [Settings/Registration] menu on the Control Panel of the host machine, select the following items and start
the Updater.
[Management Settings] > [License/Other] > [Register/Update Software]
2. Press [Install Applications/Options], and the <Install Applications/Options> screen will appear. Enter the license
number and press [Start].
Setting value
1024 to 65535
1024 to 65535
91
6. MEAP Application Management
Default value / Value after RAM clear
8000
8443