TeamPoS 3000 XT
3. Remove the back cover by pushing in on the
latches at the bottom and long edge, then lift
off the back cover.
4. Connect the plug to the MCR-keypad.
5. Slide the board into the grooves in the top of
the chassis. Secure with two screws.
6. Snap the MSR cover into place. Align the top
and outer edges first, then ease the tabs at the
lower edge inside the shell until they snap into
the notches.
5-6
Installation and Maintenance Manual
Mounting
edge latch
Bottom
edge latches
Connect
plug
to board
Secure
with
two
screws
Cover
D900000172