Table of Contents
Advertisement
TeamPoS 3000 XT
Hard drive
power cable
6. If you are replacing the motherboard, be sure that the jumpers are set identically to the
board you removed. Refer to the next section for details.
7. To reinstall the motherboard, make sure it lines up with the rails in the chassis.
8. Slide the motherboard into the chassis with the release lever at a 45° angle.
9. Push in slowly until the motherboard assembly engages the lever.
10. Use the lever to fully seat the motherboard assembly.
11. Reconnect the cables.
12. Reinstall the PC shield and the top cover.
13. Reconnect power.
D900000172
Figure 7-2. White Release Lever
Figure 7-3. Removing the Motherboard
Installation and Maintenance Manual
Release lever
ATA hard drive
data cable
7-5
Advertisement
Table of Contents
