TeamPoS 3000 XT
5.4. Connecting Power
To connect power to the unit:
1. Remove the cover from the left side of the power supply by inserting the special tool
between the cover and the housing and pressing toward the edge of the housing to release
the tabs. The tool is stored inside the interface panel as shown in Figure 5-7.
Cover removal tool
stored here
If the special tool is not available, use a flat blade screwdriver.
Figure 5-8. Using a Screwdriver to Remove Power Supply Cover
D900000172
Figure 5-7. Cover Removal Tool Storage Location
Press tabs toward
outside of housing to
release cover
Installation and Maintenance Manual
5-11