Table of Contents
Advertisement
TeamPos 3000XT
Chapter 9 -
BIOS
The following BIOS set-up instructions and settings are for BIOS level P09 on the
original release of the TeamPoS 3000XT terminal. The BIOS level is expected to change
throughout the life of the terminal and therefore these readings may not necessarily
reflect later versions of the BIOS. The latest BIOS version can be obtained from Fujitsu's
FTP site at
ftp://ftp.ftxs.fujitsu.com/POS/POSsustaining/Retail/TeamPOS
a user name and password is required to access the FTP site.
support for access information.
If access to the ftp site is not possible, the latest BIOS should be available
http://www.fujitsu.com/us/services/retailing/support/drivers/index.html in the near future.
If a motherboard is replaced in the field, it may be necessary to change the date and time
and set up the BIOS for the customer's configuration. The following information shows
the default screens from the factory.
Opening CMOS Setup Screen
Turn ON power and press the "F2" key while the terminal goes through the power on self
test.(POST). (It will be necessary to attach an external keyboard to do this.)
CMOS Settings
If a new motherboard has been installed, it will be necessary to set the date and time
before releasing the terminal to the customer. To change the date and time, select
STANDARD CMOS FEATURES and manually make changes by inserting the current
date and time. Run "LOAD OPTIMIZED DEFAULTS" then "SAVE & EXIT SETUP."
Other default settings may be changed at this time if the customer requires settings other
than the default settings listed here. Changing other default settings can adversely effect
the operation of the unit.
In most cases, the CMOS default settings are adequate and do not require changing.
Follow the instructions on the screen to select STANDARD CMOS SETUP. To change
the time and date follow, the instructions on the screen. Run LOAD OPTIMAL
DEFAULTS located under the "EXIT" tab. Exit, saving settings.
Note: The arrow [ ] indicates additional screens. Use [Enter] to advance to the next
screen. Text shown in blue is either dynamic, meaning it changes as the unit operates, or
it is set for automatic mode and is not selectable in that mode.
Instructions or information on how to change settings appear in the right column under
"Item Help." Information appropriate to the item selected appears under "Menu Level."
D900000172
Installation and Maintenance Manual
Please see your technical
3000XT. Note:
on
9-1
Advertisement
Table of Contents
