Table of Contents
Advertisement
TeamPoS 3000 XT
Chapter 7 - Maintenance
Caution: Confirm that the external power source is 100-240 VAC before
starting the operation. To prevent electric shock, confirm that the AC cable is
removed from the AC outlet anytime the covers are removed. Be sure to
observe all ESD precautions and power OFF procedures.
This chapter covers periodic maintenance and provides instructions for installing and replacing
those items which can be installed or replaced in the field.
7.1.
Periodic Maintenance
Only trained personnel must perform the following:
Vacuum all ventilation passageways on the control unit and peripherals. Ensure that these
passageways are open and free of dust and other debris that could restrict airflow.
Check the PSU fan for proper operation annually. See BIOS settings for typical fan speeds. If
fan speed is approaching the low end, the fan should be replaced. Fan speeds can be found under
the hardware monitoring section of the BIOS.
7.2.
Power ON and OFF Sequence
This section presents the general procedures for powering ON and powering OFF the TeamPoS
3000 XT. The instructions in this section assume that the terminal, operating system, and the
application software have been installed. For any additional power-up procedures dictated by the
retail application, refer to the manuals provided with the application software.
Caution: With the exception of USB peripherals, never disconnect or
connect a peripheral while power is on its port. To avoid damage to the
control unit and peripherals, when connecting and disconnecting RS232
peripherals, turn power OFF with the Port switch, the TeamPoS 3000 XT
power switch on the left side of the unit or by disconnecting AC power.
D900000172
Installation and Maintenance Manual
7-1
Advertisement
Table of Contents
