Longopac Bag - Husqvarna DC 655 Operator's Manual

4. Tighten a strap around the Longopac dust bag and
the container to attach the bag correctly to the
container.
5. Pull the Longopac dust bag down on the outer side
of the bag holder.
6. Close the bottom of the Longopac dust bag with a
cable tie.
To discard a full Longopac bag and prepare a
new Longopac bag
WARNING:
caution, a full Longopac bag can be heavy.
Make sure that the cable ties are closed
correctly before you lift the Longopac bag.
2061 - 001 - 13.02.2023
Lift the Longopac bag with
1. Pull out the Longopac bag (A) and attach a cable tie
(B) to close the new Longopac bag.
B
2. Shake down the dust in the used Longopac bag.
3. Attach a cable tie 10 cm/3.9 in. below the first cable
tie to close the used Longopac bag. Cut off the
Longopac bag between the cable ties.
4. If the remaining part of the Longopac bag cassette
is too small to prepare a new Longopac bag, install
a new Longopac bag cassette. Refer to
new Longopac dust bag on page 14 .
5. Obey local regulations for disposal of the full

Longopac bag.

To drain the water from the pressure
tank
Water in the pressurized air collects in the pressure
tank. It is necessary to drain the water from the pressure
tank daily.
A
To install a
15