Transportation, Storage And Disposal - Husqvarna DC 655 Operator's Manual

Problem
There is no pressure
or not sufficient pres-
sure in the pressure
tank.
Error codes on the soft starter
Some models of the product have a soft starter in the
control panel. The soft starter prevents damage to the
Indication
The LED is off.
The LED is on.
The LED flashes 1 time.
The LED flashes 2 times.
The LED flashes 3 times.
The LED flashes 4 times.
The LED flashes 5 times.
The LED flashes 6 times.
Transportation
WARNING:
transportation. The product is heavy and can
cause injury or damage if it falls or moves
during transportation.
CAUTION:
behind a vehicle.
• Make sure that the electrical cable and
dust extraction hose are disconnected before
transportation. Close the air intake when the dust
extraction hose is disconnected.
• Remove the collected dust before transportation.
• The wheels let you move the product shorter
distances. For longer distances, lock the wheels and
22
Cause
The pneumatic system is damaged.
The compressor filters are dirty.
Problem
The product does not start.
The product does not start.
Overload
Over temperature
Phase reversal
Phase loss/open load.
Phase imbalance.
Shorted SCR.

Transportation, storage and disposal

Be careful during
Do not tow the product
Solution
Do a check of the pneumatic system.
Clean the compressor filters. Refer to
clean the compressor filters on page 17 .
electrical equipment and gives information about the
failure.
Solution
Do a check of the power connections and the power
source.
Make sure that the isolation contactor is correctly con-
nected.
Make sure that the product is connected to a power
source.
Find the cause for the overload. Push the reset button to
reset.
Let the product become cool.
Do a check of the sequence of the phases.
Confirm that 3 phases are present. 1 or 2 phases could
be missing.
Do a check of the voltage in each phase. The phase unit
trips if the difference is more than 50%.
Speak to an approved service agent.
lift the product to move it or put the product on a
vehicle.
• Put some type of protection on the product during
transportation. The protection keeps rain and snow
away from the product.
• Make sure that there is no pressure in the pressure
tank before transportation.
To move the product
WARNING:
are stationary before you move the product.
WARNING:
steel toe-cap and non-slip sole.
To
Wait until all moving parts
Use protective boots with
2061 - 001 - 13.02.2023