Husqvarna DC 655 Operator's Manual page 20

4. Remove the lock bar and tilt the filter brackets down.
5. Pull out the 3 primary filters and put them carefully in
a plastic bag.
WARNING:
remove the primary filters. The particles
in the primary filters are dangerous to
your health.
6. Discard the plastic bag correctly. Refer to local
regulations.
7. Push 3 new primary filters on the filter brackets in to
the filter housing. Install 1 filter at a time. Make sure
that you do not put the edges of the primary filters on
top of each other.
20
Be careful when you
WARNING:
not installed correctly, dust can come
in to the air. The dust particles are
dangerous to your health.
8. Install the lock bar.
9. Install the 3 nuts. Make sure that there is no space
between the nuts.
CAUTION:
correctly installed on the screw that
holds the lock bar. Dust in the filter
housing and can cause damage to the
threads on the screw.
10. Do the same replacement procedure on the other 2
rows of primary filters.
11. Install the cover of the filter housing and the 6 nuts.
To replace the filter in the water separator
1. Stop the product. Refer to
page 12 .
2. Remove the bowl of the water separator (A).
3. Replace the filter of the water separator (B).
4. Install the bowl of the water separator.
If the primary filters are
The 3 nuts must be
To stop the product on
B
A
2061 - 001 - 13.02.2023