Advertisement
5
Insert the main charger unit along the guide groove in the copier
fully to the bottom.
Main charger unit
5. Developing unit setting
A. Developing unit setting
1
Open the front cabinet, remove the installation toner fixed to the
developing unit level with tape, and pull the developing unit lever
toward you.
2
Hold the grip of the developing unit, and slowly pull out the
developing unit until it stops.
Then hold the hand carry strap and press the developing lever,
and remove the developing unit.
DV lever
Developing unit
Hand carry strap
Grip
4 – 4
3
Remove three fixing screws of the toner hopper of the developing
unit, and remove the toner hopper.
Fixing screw
Toner hopper
4
While supplying developer from the developer supply port of the
developing unit, turn the MG gear clockwise with a screwdriver or
a scale to supply fully in the developing unit.
Developer
supply port
MG gear
Screwdriver (+) or scale
5
Install the toner hopper to the developing unit and fix it with two
screws.
Toner hopper
Fixing screw
Fixing screw
Developing unit
Developer
Developing unit
Fixing screw
Developing unit
Advertisement
