Advertisement
2-2. Transport belt
1
Remove the fusing unit.
2
Remove the TC case.
3
Disengage the transport belt drive shaft holder on the TC case
side, then disengage the drive shaft on the paper exit side and
remove the belt.
(Note for assembly)
1
There is a mark ( î ) on the transport belt. Set so that the tip of
the mark faces toward the paper exit direction.
2
Be careful of the installing direction of the transport belt drive
shaft.
3. Fusing section
3-1. Fusing unit removal
1
Open the front cover.
2
Push the open/close lever down to the right side, and slowly open
the upper unit.
3
Remove the fixing screw of the fusing connector cover and
remove the cover.
4
Remove two connectors from the unit.
5
Remove the stop ring and remove the unit.
(Note for assembly)
When removing the unit from the copier, ba careful not to scratch the
photoconductor drum and the lower heat roller. Be careful not to
break the actuator of the paper exit sensor (POD).
6 – 4
Advertisement
