Advertisement
6
Hold the hand carry strap of the developing unit and insert it into
the copier fully to the bottom.
7
Close the developing unit lever and close the front cabinet.
With the above procedure, setting of the developing unit is com-
pleted.
6. Toner density sensor level adjustment
Turn on the copier power switch.
A. Developing unit level adjustment
1
Execute simulation 25.
C
5
2
After 3 minutes, simulation 25 is completed.
(Note) If the simulation is terminated halfway, automatic reading
is not performed. Do not terminate it halfway.
3
Cancel simulation 25 with the CA key.
Hand carry strap
Developing unit
Grip
Developing unit lever
Front cabinet
0
2
2
7. Accessory installation
A. Copier tray installation
Install the copy tray to the paper exit section on the left side of the
copier.
Copy tray
8. Toner supply
1
Open the front cover.
2
Pull down the developer unit lock lever and pull the developer unit
out slowly unit it stops.
4 – 5
Advertisement
