Advertisement
4
Remove the screw and remove the charging plate (saw teeth)
ass'y.
(Cleaning/replacement and note)
1
When attaching the screen grid, be careful not to deform and dirt
the screen grid. Check that the screen grid is securely in position.
2
Be careful not to deform the saw teeth edge of the saw teeth
ass'y.
3
Do not touch the inside (saw teeth ass'y) of the MC case, the
screen grid, and the saw teeth.
4
To clean the MC saw teeth, push styrene foam onto the saw teeth
at right angles and remove dirt.
5-2. Transfer/separation charger (TC/SC) unit
1
Open the font cover, open the body up.
2
Push TC/SC unit pawl sections
side and pull it out.
(Cleaning/replacement and precautions)
Set the charger SP length to 17 ±1.0mm.
1
2
The charger wire must be free from distortion and deformation,
and must be in the wire positioning groove of each holder.
3
The charger case must be free from oil, dirt or adhesion of foreign
material.
3~5mm
4
Clean the wire with alcohol.
6 – 16
A
(2 positions) and lift the front
A
17 1.0
Advertisement
