Sharp 00ZSF1116/A1E Service Manual page 118

Pin No. Port Signal name
52 P27 AD15
53 P50 AD16
54 P51 LHPS
55 P52 PPD
56 P53 MCS
57 VSS VSS
58 P60 BACK
59 P61 BREQ
60 P62 WAIT
61 S-CLK S-CLK
62 /STBY /STBY
63 /RES /RESET
64 NMI NMI
65 VSS VSS
66 EXTAL EXTAL
67 XTEL XTEL
68 VCC VCC
69 P63 /AS
70 P64 /RD
71 P65 /HWR
72 P66 /LWR
73 MD0 MD0
74 MD1 MD1
75 MD2 MD2
76 AVCC AVCC
77 VREF VREF
78 P70 AES
79 P71 TH
80 P72 TCS
81 P73 PROCON
82 P74 DVC
83 P75 PD
84 P76 BLDATA
85 P77 PCG
86 AVSS GND
87 P80 MHPS
88 P81 FWS
89 P82 /CS2
90 P83 /CS1
91 P84 TFD
92 VSS GND
93 PA0 LED0
94 PA1 LED1
95 PA2 CLPWM
96 PA3 MMRE
97 PA4 GBPWM
98 PA5 PFMCLK
99 PA6 TM0
100 PA7 TM1
IN/OUT H/L
Address signal
Address signal
IN L Lens home position signal (LOW at 100%)
IN H Transport pass sensor signal (HIGH when paper is sensed.)
IN H Drum marking sensor signal
Power (GND)
IN H Back signal (fixed to H)
IN H Break signal (fixed to H)
IN H Wait signal (fixed to H)
OUT H System clock (Fixed to HIGH)
IN H Standby signal (Fixed to HIGH)
IN L Reset at LOW.
Non-maskable interruption (Fixed to LOW.)
Power (GND)
IN Clock (8MHz)
IN Clock (8MHz)
Power (+5V2)
OUT H Address strobe signal (Fixed to HIGH.)
OUT L ROM. I/O data read signal
OUT L I/O data write signal
OUT H Lower write signal (Fixed to HIGH.)
IN H Mode set signal (Fixed to HIGH.)
IN L Mode set signal (Fixed to LOW.)
IN H Mode set signal (Fixed to HIGH.)
A/D, D/A convertor power
A/D, D/A convertor reference voltage
IN AE sensor signal (Analog input signal)
IN Thermistor signal (Analog input signal)
IN Toner density sensor signal (Analog input signal)
IN Process control signal (Analog input signal)
IN Developing unit color detection signal (Analog input signal)
IN Original sensor signal (Analog input signal)
OUT Blank lamp data signal (Analog input signal)
OUT Process control gain signal
IN H Mirror home position sensor signal
IN Zero cross detection signal
OUT L Chip select signal (I/O) (I/O is selected at LOW.)
OUT L Chip select signal (EPROM) (EPROM is selected at LOW.)
IN H Waste toner sensor signal (Toner full at HIGH)
Power (GND)
OUT H Original detection LED lighting signal 0 (ON at HIGH)
OUT Original detection LED lighting signal 1 (ON at HIGH)
OUT Copy lamp control signal (PWM signal)
IN Main motor rotary encoder detection signal
OUT Grid bias control signal (PWM signal)
OUT Paper feed motor clock signal
OUT H Toner supply motor drive signal 0 (ON at HIGH)
OUT H Toner supply motor drive signal 1 (ON at HIGH)
12 – 7
Specifications