Advertisement
4
While pushing waste toner bottle in the direction of
and remove.
A
(Note for assembly/maintenance)
1
As shown in the figure below, attach so that two projections of
g
gear 19T
are on the rear frame side (on the screws supporting
f
plate
side).
2
Replace the waste toner bottle when waste toner full is detected
or at 50K maintenance. At this time, clean and remove the waste
toner from waste toner pipe
A
A
and lift it
g
f
A
.
6-3. Drum (Replace every 60K copies)
1
Remove the process unit from the copier. (Refer to 6-1.)
2
Loosen two blue screws which are fixing the drum, rotate the plate
slightly to the right and pull it out.
3
Remove the drum.
<Note> Be careful not to scratch the drum.
6-4. Blank lamp unit (Clean every 60K copies.)
1
Remove three blue screws which are fixing the process unit
holder, slide the holder and remove it.
2
Tighten the blank lamp unit position adjustment screw completely,
and remove the unit rear side, then loosen the screw.
3
Remove two connectors of the blank lamp PWB, and remove the
blank lamp unit.
<Note> When the unit is installed or replaced, adjust according to
"Blank lamp position adjustment" in [7] ADJUSTMENTS.
6 – 18
Advertisement
