Advertisement
Main code
Sub code
25
01
Drive system check
Used to turn on the main motor, the developing bias, and the discharge lamp for 3 min.
The input value of the toner density is displayed on the second digit of the copy quantity display during the main
motor is rotating.
02
Automatic developer adjustment
Same as SIM 25-1. The average value of toner density sensor inputs is stored as the toner density adjustment
value after 3 min from starting the main motor rotation.
The display on the copy quantity display is same as SIM 25-1.
26
05
Count mode setting
Used to set the count mode of the total counter, the developer counter (mini maintenance counter for Japan), and
the maintenance counter in A3/WLT copy.
When this simulation is executed, the currently set count mode is displayed on the copy quantity display.
Enter the set value and press the PRINT button to store it.
06
Destination setting
Used to set the destination (Japan, SEC, etc.).
When this simulation is executed, the currently set destination is displayed on the copy quantity display.
Enter the set value and press the PRINT button to store it.
07
Drum sensitivity setting
Used to set the drum sensitivity.
When this simulation is executed, the currently set drum sensitivity is displayed on the copy quantity display.
Enter the set value and press the PRINT button to store it.
Copy quantity display
Third digit
Second, first digit
1 ∼ 99
A
Set value
Total/Developer counter
0
Double count
1
Single count
2
Double count
3
Single count
Set value
Destination
0
Japan
1
SEC
2
SECL
3
SEEG
4
SUK
5
SCA
6
EX inch series
7
EX AB series
8
EX inch series (FC)
9
EX AB series (FC)
10
Taiwan/China
Set value
Drum sensitivity
1
1
2
2
3
3
Content
Color of developer
Black
Maintenance count
Double count
Double count
Single count
Single count
← Initial value
8 – 7
← Initial value
Advertisement
