Advertisement
Main code
Sub code
26
10
AE original density setting
Used to set the original density.
When this simulation is executed, the currently set original density is displayed on the copy quantity display.
Enter the set value and press the PRINT button to store it.
When a dark original is copied in the AE mode, the lead edge (about 4mm) is not copied. If it is necessary to copy
the lead edge, set this simulation to "1."
13
Warm-up mode setting
Used to set the main motor operation mode during warm-up.
When this simulation is executed, the currently set warm-up mode is displayed on the copy quantity display.
Enter the set value and press the PRINT button to store it.
18
Toner save mode setting (Japan/SUK only)
Used to set ON/OFF of the toner save mode.
When this simulation is executed, the currently set value is displayed on the copy quantity display.
Enter the set value and press the PRINT button to store it.
20
Rear edge void setting
Used to set YES/NO of the paper rear edge void.
When this simulation is executed, the currently set rear edge void mode is displayed on the copy quantity display.
Enter the set value and press the PRINT button to store it.
29
AC power voltage setting
Used to set the AC power voltage to 100V or 200V.
(For compliance with the CE mark)
Set value
Original density
0
Normal
1
Thin original
Set value
Warm-up mode
0
Normal mode
1
The main motor rotates until warm-up is completed.
Set value
Toner save mode
0
ON
1
OFF
Set value
Rear edge void
0
Yes
1
No
Set value
Power voltage
0
100V series
1
200V series
Content
← Initial value
← Initial value
← Initial value
← Initial value
8 – 8
← Initial value
Advertisement
