Table of Contents
Advertisement
Mounting
5.3 Mounting with built-in ring light and EF lens
Mounting the individual components
①
②
③
④
Figure 5-4
Proceed as follows to mount the SIMATIC MV540 optical reader with built-in ring light, lens
and protective lens barrel:
1. Remove the protective foil from the reader.
2. Mount the ring light holder
– Make sure that the ring light holder is aligned correctly and fully flush when it is
– Fasten the ring light holder
3. Insert the straight connector of the lens cable into the interface of the reader (a).
4. Screw the desired lens
Ensure the correct alignment of the lens so that the interface is close to the
cutout/interface (a). If needed, unscrew the lens slightly. If needed, align the lens using
the knurled nut/spring/counter ring.
5. Use the lens cable to connect the EF lens to the reader
Insert the angled connector of the lens cable into the interface of the lens and the straight
connector into the interface of the camera. Ensure that the cable does not become
twisted.
6. Insert the micro SD adapter
If needed, insert a micro SD card into the adapter
7. Insert the connection board
68
Lens
Ring light holder
MV540 optical reader
M2.5 hexagon socket-head screws (3x)
Setup of SIMATIC MV540 optical reader with built-in ring light, EF lens and protective
lens barrel
mounted. If needed, turn one of the hexagon socket screws back a little.
reader (≤ 0.45 Nm).
①
⑤
⑥
⑦
⑧
②
.
②
with the three hexagon socket screws
into the lens mount of the reader
⑤
into the reader interface provided.
⑥
into the reader interface provided.
Operating Instructions, 05/2019, C79000-G8976-C494-02
Micro SD adapter
Connection board
Built-in ring light (including attachment)
Protective lens barrel
④
③
.
③
.
onto the
SIMATIC MV500
Advertisement
Table of Contents
