Table of Contents
Advertisement
5.2
Mounting with built-in ring light and mini-lens
Disconnecting SIMATIC MV500 from the power supply
Make sure that the power supply is switched off when installing/uninstalling the devices as
well as the internal ring light, EF lens and micro SD adapter.
①
②
③
Figure 5-1
Proceed as follows to mount the SIMATIC MV540 optical reader with built-in ring light, mini-
lens and protective lens barrel:
1. Remove the protective foil from the reader.
2. Mount the ring light/ring light holder
– Make sure that the ring light holder is aligned correctly and fully flush when it is
– Fasten the ring light holder
3. Screw the desired lens
4. Insert the micro SD adapter
If needed, insert a micro SD card into the adapter
5. If needed, replace the attachment of the built-in ring light.
The attachments can be easily removed from the ring light or placed on it. Ensure that the
attachment is correctly aligned.
You can find detailed information on the ring light attachments in the following section.
SIMATIC MV500
Operating Instructions, 05/2019, C79000-G8976-C494-02
CAUTION
Lens
MV540 optical reader
Right light / Ring light holder
Setup of SIMATIC MV540 optical reader with built-in ring light, mini-lens and protective
lens barrel
mounted. If needed, turn one of the hexagon socket screws back a little.
reader (≤ 0.45 Nm).
①
5.2 Mounting with built-in ring light and mini-lens
④
⑤
⑥
③
.
③
with the three hexagon socket screws
into the lens mount of the reader
⑤
into the reader interface provided
M2.5 hexagon socket-head screws (3x)
Micro SD adapter
Protective lens barrel
④
②
.
②
.
Mounting
onto the
65
Advertisement
Table of Contents
