NEC Express5800/R120g-1E Maintenance Manual page 195

Chapter 3 Appendix
Error Message
Internal Flash is not valid.
C600
Invalid internal BIOS
C624
Configuration Data.
BIOS Configuration Data Send
C625
Error.
BIOS Configuration Data Read
C626
Error.
BIOS Configuration Data Write
C627
Error.
System configuration data
C628
cleared by System Boot Options
command.
Cause
Internal Flash Memory was
specified by a one-time boot device
but could not be enabled.
Internal error of BIOS Configuration
Data was detected.
This is an error when BIOS
Configuration Data is sent.
This is a read error on BIOS
Configuration Data.
This is a write error on BIOS
Configuration Data.
The SETUP settings were cleared
by the standard IPMI-compliant
command of "Set System Boot
Options."
Express5800/R120g-1E Maintenance Guide
1. POST Error Message
Solution
Unplug the power cord, wait for at least 30
seconds, then restart the server. If the same
error is detected repeatedly, contact your
sales representative.
Run SETUP and re-specify each item.
If the problem cannot be solved, contact your
sales representative.
195