Problem Of Starting Os - NEC Express5800/R120g-1E Maintenance Manual

Chapter 1 Maintenance
5.4

Problem of Starting OS

[?] Unable to start OS
 Have the settings of the RAID controller changed?
→ Specify the correct settings with RAID Configuration Utility (Off-line Utility or LSI Software RAID
Configuration Utility).
 Is the RAID controller found by POST?
→
Be sure to connect the RAID controller correctly and retry.
 Is the RAID controller installed firmly straight into the PCI slot?
→
Install the RAID controller properly.
 Is the RAID controller mounted on the PCI slot for which the mounting is restricted?
→ Check the mounting restrictions of the server and then mount the RAID controller on the correct slot.
 Are the hard disk drives properly installed?
→ Install the hard disk drives properly.
 Is the SAS cable connected to the hard disk drive correctly?
→
Connect the SAS cable properly.
 Is the EXPRESSBUILDER DVD inserted?
→
Remove the EXPRESSBUILDER DVD and restart.
 Is a cartridge inserted into N8151-86 with built-in RDX (USB)?
→ Either remove the cartridge or change the boot order in BIOS Setup.
 Is a disk array unit connected to the PCI card?
→
Change the boot order from BBS Priorities of the BIOS Setup Utility.
Express5800/R120g-1E Maintenance Guide
5. Troubleshooting
33