NEC Express5800/R120g-1E Maintenance Manual page 77

Chapter 2 Useful Features
For details about the options, see the table below.
Serial Port A Settings
Serial Port A
Serial A Base I/O
Serial A Interrupt
Serial Port B Settings
Serial Port B
Serial B Base I/O
Serial B Interrupt
Auto-Shutdown
Console Redirection Settings
BIOS Redirection Port
Terminal Type
Baud Rate
Data Bits
Parity
Stop Bits
Flow Control
Continue C.R. after POST
Option
Disabled
[Enabled]
[3F8h]
2F8h
3E8h
2E8h
[IRQ 4]
IRQ 3
Disabled
[Enabled]
3F8h
[2F8h]
3E8h
2E8h
IRQ 4
[IRQ 3]
[Disabled]
Enabled
[Disabled]
Serial Port A
Serial Port B
[VT100+]
VT-UTF8
PC-ANSI
9600
19200
57600
[115200]
7
[8]
[None]
Even
Odd
[1]
2
None
[Hardware RTS/CTS]
Disabled
[Enabled]
Express5800/R120g-1E Maintenance Guide
Parameter
−
Enable or disable serial port A
Specify the base I/O address for serial port A.
Specify the interrupt for serial port A
−
Enable or disable serial port B
Specify the base I/O address for serial port B
Specify the interrupt for serial port B
Enable or disable auto shutdown for the serial
port. To specify "Enabled", a device that
supports this feature must be connected. If the
connected device does not support this
feature, the serial ports will fail to return from
halt state.
−
Enable or disable console redirection for a
specified serial port. Specifying "Serial Port A"
or "Serial Port B" allows direct connection via
a terminal unit such as NEC ESMPRO
Manager. The screen size of the terminal unit
must be 80 x 25. The option items shown
below are displayed.
Select the terminal type.
Specify the baud rate.
Specify the data bit width.
Specify the parity type.
Specify the number of stop bits.
Specify the flow control method.
Select whether to continue console redirection
after completion of POST.
1. System BIOS
Description
−
−
−
[ ]: Factory setting
77