Problem Of Os Operation - NEC Express5800/R120g-1E Maintenance Manual

Chapter 1 Maintenance
5.7

Problem of OS Operation

[?] Windows operation is unstable
 Have you installed Starter Pack?
→ See "Installation Guide (Windows)" to install Starter Pack.
If you restore the Windows from a backup tool, Starter Pack is needed to install again.
[?] Cannot turn the power OFF at the blue screen (STOP error screen)
→
Perform the forced shutdown (continue to press the power switch at least four seconds) to turn off the
server.
[?] Unable to connect to a network
 Is the cable connected properly?
→
Securely connect the proper cable to the network port on the rear of the server. Additionally, make sure
that the cable conforms to the network interface standards.
 Are BIOS settings correct?
→ Check the BIOS settings with BIOS Setup Utility.
 Have you completed protocol and services settings?
→ Confirm that the network driver for the server has been installed and various settings, such as TCP/IP
protocol, have been properly specified.
 Are transfer rate settings correct?
→
Confirm that the transfer rate and duplex mode are the same as those of the connecting hubs.
Express5800/R120g-1E Maintenance Guide
5. Troubleshooting
39