Problem Of Os Operation - NEC Express5800/R120g Maintenance Manual

Chapter 1 Maintenance
5.7

Problem of OS Operation

[?] Windows operation is unstable
Have you installed Starter Pack?

→ See "Installation Guide (Windows)" to install Starter Pack.
If you restore the Windows from a backup tool, Starter Pack is needed to install again.
[?] Cannot turn the power OFF at the blue screen (STOP error screen)
→ Perform the forced shutdown (continue to press the power switch at least four seconds) to turn off the
server.
[?] Unable to connect to a network
Is the cable connected properly?

→ Securely connect the proper cable to the network port on the rear of the server. Additionally, make sure
that the cable conforms to the network interface standards.
Are BIOS settings correct?

→ Check the BIOS settings with BIOS Setup Utility.
Have you completed protocol and services settings?

→ Confirm that the network driver for the server has been installed and various settings, such as TCP/IP
protocol, have been properly specified.
Are transfer rate settings correct?

→ Confirm that the transfer rate and duplex mode are the same as those of the connecting hubs.
42
Express5800/R120g-2E, T120g Maintenance Guide
5. Troubleshooting