Table of Contents
Advertisement
Chapter 3 Appendix
Windows Server 2012
System Log
b57nd60a
4
When installing an OS, starting system,
or applying Starter Pack
l2nd
4
When installing an OS
l2nd
4
When starting system, or applying Starter
Pack
mlx4_bus
24
At the time of system start-up
ixgbi
27
When installing an OS
ixgbt
27
When starting system, or applying Starter
Pack
volmgr
46
When installing an OS
Microsoft-Windows-
Time-Service
134
When installing an OS, booting the
system, or applying Starter Pack
Broadcom NetXtreme Gigabit Ethernet #xx: The network link is down.
Warning
Check to make sure the network cable is properly connected.
This event does not affect system operation.
Broadcom BCM57810 #xx: The network link is down. Check to make
Warning
sure the network cable is properly connected.
This event does not affect system operation.
QLogic BCM57810 #xx: The network link is down. Check to make sure
Warning
the network cable is properly connected.
This event does not affect system operation.
MLX4_SF_32_0_0:
Problem - The port was configured to use auto sensing for deciding the
port type. The port * failed to detect the port type automatically.
Impact - As a result the port is started as IB port (unless the port is
ETH only). This may cause a connection problem if the other side is
ETH port.
Warning
Reason and suggestion to fix - This problem may happen since the
computer is connected back to back or the cable is unplugged.
For solving this issue connect the port to a switch or define the port type
explicitly (IB or ETH) instead of auto.
* There may be cases that the above message is somewhat different.
This event is logged in the system when InfiniBand Adapter is
connected.
This event will be recorded when the type of port could not be
recognized automatically such as InfiniBand cable is not connected.
Intel(R) Ethernet Controller 10 Gigabit X540-AT2 #xx
Warning
Network link is disconnected.
This event does not affect system operation.
Intel(R) Ethernet Controller X540-AT2 #xx
Warning
Network link is disconnected.
This event does not affect system operation.
Error
Crash dump initialization failed!
Go to the following Microsoft website for details.
http://support.microsoft.com/kb/2756313
NtpClient was unable to set a manual peer to use as a time source
because of a DNS resolution error on 'time.windows.com,0x9'.
Warning
NtpClient will try again in 15 minutes and double the reattempt interval
thereafter. The error was: No such host is known. (0x80072AF9)
If it is not registered after connecting to the Internet, there is no problem
with system operation.
Express5800/R120g-2E, T120g Maintenance Guide
2. List of Windows Event Logs
217
Advertisement
Table of Contents
