Problem Of Installing Os - NEC Express5800/R120g Maintenance Manual

Chapter 1 Maintenance
5.3

Problem of Installing OS

[?] Unable to create a partition when installing Windows Server 2012 R2 or Windows Server 2012
Is the following message displayed?

→ Delete the partition created, and then create a new partition again.
partition you are going to remove. For details, refer to the Microsoft website below:
Windows Server 2012 R2
https://technet.microsoft.com/en-us/library/dn387077.aspx
Windows Server 2012
https://technet.microsoft.com/en-us/library/jj574225.aspx
[?] Unable to install OS
Is the hard disk drive properly installed?

→ Make sure that the hard disk drive is installed securely and that cables are properly connected.
Is the disk format correct?

→ Follow the table below to create a partition depending on the boot mode.
Boot mode
UEFI Mode
Legacy Mode
For example, the following message appears if an MBR disk is specified as the system drive of Windows
on UEFI boot mode.
→ To change the disk format, clear the partition configuration and create a new partition. All of the data on
the hard disk drive will delete. Back up necessary data before clearing the partition configuration.
Did you configure the RAID controller?

→
For a RAID system, use EXPRESSBUILDER or RAID Configuration Utility (Off-line Utility or LSI
Software RAID Configuration Utility) to properly configure the RAID controller before installing OS.
Did you create a logical drive?

→
For a RAID system, create a logical drive using EXPRESSBUILDER or RAID Configuration Utility
(Off-line Utility or LSI Software RAID Configuration Utility) to install OS.
Disk format
GPT (GUID partition table)
MBR (master boot record)
Express5800/R120g-2E, T120g Maintenance Guide
5. Troubleshooting
31