Table of Contents
Advertisement
Chapter 3 Appendix
(3) Error messages on a virtual LCD
You can confirm the error messages by the EXPRESSSCOPE Engine 3 web browser window. See
EXPRESSSCOPE Engine 3 User's Guide for details.
The table below shows the error messages displayed on upper and lower lines, cause, and solution.
•
Messages displayed on an upper LCD line
BIOS Message
on Upper LCD Line
XX POST Started...
XX BIOS Rev YYYY
POST Completed Successfully
POST ERROR XXXX
No Available Memory in System No available memory is implemented. Make sure that the memory is correctly
Error Pause in POST
Entering BIOS SETUP MENU
Waiting for normal temperature A temperature abnormality was
BIOS Recovery Running
BIOS Updater Running
System Configuration change is
detected
PCI Bus System Error 1
PCI Bus Parity Error 1
CPUx_DIMMx Correctable Error
(x: DIMM number)
Memory DIMM Sparing Fail-over
on CPUx (x: CPU socket number)
Memory Mirroring Fail-over on
CPUx (x: socket number)
206
Cause
This message appears while POST is
running.
"XX" means a POST code in
progress.
This message appears while POST is
running.
"XX" means a POST code in
progress, and "YYYY" means the
system BIOS version.
POST completes normally.
Error XXXX occurred during POST.
POST detected an error and paused. Check the displayed message and take
Starting up BIOS SETUP MENU.
detected inside the server.
BIOS recovery is in progress.
BIOS update is in progress.
The CPU or memory configuration
has changed since the previous
startup.
A system error was detected in PCI
bus.
A parity error was detected in PCI
bus.
A frequent occurrence of correctable
memory error was detected.
Memory Sparing feature failed over to
standby memory.
Memory Mirroring feature failed over
to standby memory.
Express5800/R120g-2E, T120g Maintenance Guide
1. POST Error Message
Message displayed on
upper LCD line
Message sent from BIOS
Message displayed on lower
LCD line
Message sent from BMC
Solution
This is not an error.
Check the displayed message and take
an appropriate action.
implemented.
an appropriate action.
This is not an error. This message will
disappear when SETUP operation is
completed.
Lower the room temperature or turn off
the power to cool the server to room
temperature before starting up the
server. If this abnormality continues to
occur, check if a fan has failed. If the
same error still continues to occur,
contact your representative.
This is not an error. Wait until BIOS
update is completed.
If this message appears even when no
configuration change has been made,
contact your sales representative
Contact your sales representative.
Advertisement
Table of Contents
