Fleetsync Radio Versions - Kenwood FleetSync 80 Series Application Manual

FleetSync™ Radio Versions
Based on customer input Kenwood has made firmware and hardware design changes to the 80
series radios to add new features and improve upon existing features. The new design is called 80
series Version 2. These radios can be identified by the logos located on the radio front panel.
The mobile units logo has been changed from a white Kenwood logo to a Orange logo. The
portables Kenwood logo's triangle [above the "W"] has been changed from white to orange. The
Model/FCC ID label will read Ver- 2. The table below shows the changes made in version 2
compared with version 1.
Caller ID
( PTT ANI Decode )
Selective Call ID Stack
(Last 3 Calls)
PTT ID Side Tone
PTT ID TA Inhibit
ID List Capacity
Status Message
Capacity
ID / Status Access
PTT ID Type
TX Inhibit Per ID /
Status
BCL
FleetSync™ Horn Alert
Note 1
Emergency Man Down
Note 1
Emergency Mode
Disable
Emergency Locator
Tones
Com Port Configuration 1 For GPS
11/01 Rev 2.0
FleetSync Application Guide
Version 1 Version 2
N/A
N/A
N/A
N/A
32
32
Rotary
Encoder
On / Off
N/A
On / Off
N/A
N/A
N/A
N/A
1 For
Messaging
Note 1 – Additional Equipment Required
80 Series Version 2
Standard
Standard
Standard
Standard
100
50
C&D Keys
Own/Sel
Standard
Off / QT-
DQT Tone
/ Optional
Signaling
Special
Status 89
Special
Status 98
Special
Status 88
Before and
After
Emergency
Same as
Version 1
or 1 for
Both
4