Table of Contents
Advertisement
Note: The solution for this error may involve a system board replacement. If TPM encryption has
been enabled, back up TPM Encryption Recovery Key.
• FQXSFPU0031N: The number of POST attempts has reached the value configured in F1 setup.The
system has booted with default UEFI settings. User specified settings have been preserved and will
be used on subsequent boots unless modified before rebooting.
Severity: Error
User Action:
Complete the following steps:
1. Original UEFI settings are still present. If customer desires to continue using the original settings,
select Save Settings.
2. If User did not intentionally trigger the reboots, check logs for probable cause. For example, if there
is a battery fault event, follow the steps to resolve that event.
3. Undo recent system changes (settings or devices added). Verify that the system boots. Then, re-
install options one at a time to locate the problem.
4. Check Lenovo Support site for an applicable service bulletin or firmware update that applies to this
error. Update UEFI firmware if applicable.
5. Save customer's UEFI configurations, then remove and re-install CMOS battery for 30 seconds to
clear CMOS contents. If it boots successfully, then restore system settings.
6. If the problem persists, collect Service Data logs and contact Lenovo Support.
Note: The solution for this error may involve a system board replacement. If TPM encryption has
been enabled, back up TPM Encryption Recovery Key.
• FQXSFPU0033G: Processor has been disabled.
Severity: Warning
User Action:
Complete the following steps:
1. Check Lenovo Support site for an applicable service bulletin or UEFI firmware update that applies to
this error.
2. Reboot the system.
3. If the problem persists, collect Service Data logs.
4. Contact Lenovo Support.
Note: The solution for this error may involve a system board replacement. If TPM encryption has
been enabled, back up TPM Encryption Recovery Key.
• FQXSFPU0034L: The TPM could not be initialized properly.
Severity: Error
User Action:
Complete the following steps:
1. Reboot the system. Reflash UEFI image.
2. If the problem persists, collect Service Data logs and contact Lenovo Support.
Note: The solution for this error may involve a system board replacement. If TPM encryption has
been enabled, back up TPM Encryption Recovery Key.
• FQXSFPU0062F: System uncorrected recoverable error happened in Processor [arg1] Core [arg2]
MC bank [arg3] with MC Status [arg4], MC Address [arg5], and MC Misc [arg6].
176
ThinkSystem SD650 Dual Node DWC Tray and NeXtScale n1200 DWC Enclosure Messages and Codes Reference
Advertisement
Table of Contents
