Fujitsu ApeosPrint C4030 Reference Manual page 63

Item
[Warmer Mode]
[Print-on-Demand
Duration]
[Power Saver Settings]
Item
[Power Saver Timers]
[Enter Power Saver After
Printing Ends]
[Sleep Mode Settings]
[Power Saver Deactivation]
[Scheduled Power Off]
[Audio Tones]
Sets type and volume of audio output during operation and when an error occurs.
You can set whether to repeat the alert on [Continuous Alert/Warning Tone]. If it is set enabled, the
alert repeats until the error is cleared or the user operate on the control panel.
Enables entry to Warmer Mode for preventing or reducing
condensation inside the machine.
If you select [On] and set [Start Time - Hour] and [Duration],

Warmer Mode is enabled during the set time.
If it is set to [Auto Start], the Warmer Mode becomes active

automatically based on the prediction of condensation regardless
of selecting [Off] or [On]. The machine enters the Warmer Mode
at the specified [Start Time - Hour].
If you apply a check mark in [Auto Stop], the Warmer Mode

becomes deactivated automatically when no condensation occurs
for a certain period.
If [Condensation Alert] is enabled, a message appears when the

machine detects a possibility of condensation occurrence.
Note
Setting by a service representative may be necessary, depending on

the product.
Sets enabled time when printing using web applications. A print
instruction is disabled when no print data is received from the
remote server within the time set here after the print instruction.
Input the time for entering each mode.
Sets timing for entering Power Saver Mode after printing has been
finished.
For operation during Sleep Mode, sets whether [Prioritize Power
Saver] or [Prioritize Wake Up Time].
Set whether to allow the machine to supply power only to the
components necessary to activate, when exiting Power Saver mode.
Sets so power goes off at the set time.
Description
Description
5.2 [System Settings]
63