•
Install the previously removed Camera Interface D100 and any other boards which were
removed from the defective board.
•
Place the new CPU board on its guide rails. Push the CPU board toward the front of the
box until it fits into the correct position.
•
Mount the four interface and power plugs on the CPU board (refer to Fig. 3).
•
Fasten the two screws on the back of the box (C and D refer to Fig. 2).
•
Connect all cables on the back of the box and ensure that they match their original
status.
•
Mount the top cover of the box (refer to chapter 1).
•
Switch on the system.
•
Ensure that the system is operating properly.
MAMMOMAT 3000 Opdima
Service
Register 5
SPB7-230.061.02
Rev. 02
Page 4 of 20
05.99
SPS-UD
Siemens-Elema AB
Solna, Sweden