•
If the new drive does not have guiding rails, remove them from the old drive and mount
the guiding rails on the new drive.
•
Set the jumpers and switches on the new disk drive as indicated (refer to Fig. 4).
•
Place the new disk drive carefully in its slot and push it firmly into the box until the basic
connector clicks into place.
•
Close the plastic door.
•
Close the metal frame.
•
Switch on the system.
•
Halt the system by pressing "STOP" "A".
•
Enter the following on the keyboard
ok probe-scsi
Fig. 7 Test of the SCSI bus
•
The system should show all the drives connected to the bus (refer to Fig. 3).
•
If the disk drives shows up correctly load the software (refer to chapter "Loading the
System Software").
See MAMMOMAT 3000 Opdima™ Digital Biopsy and Spot Imaging System - Service
Instructions (SPB7-230.061.03.......)
MAMMOMAT 3000 Opdima
Service
Register 5
SPB7-230.061.02
Rev. 02
Page 6 of 10
05.99
SPS-UD
3
Siemens-Elema AB
Solna, Sweden