Installing The Safety Chain - Toro 68004C Operator's Manual

Figure 5
1. Support points
3. Remove the 2 nuts and bolts that secure the
front stabilizer leg to the frame
remove the front stabilizer leg.
Figure 6
1. Front stabilizer leg
4. Install the tongue into the opening at the front
of the machine and secure it with 6 nuts and
short bolts torqued to 102 N∙m (75 ft-lb); refer
to Figure 7.
Figure 7
1. Clevis pin
2. Long bolt
3. Short bolt
g021091
(Figure 6) and
g021092
g021093
4. Nut
5. Tongue
6. Front stabilizer leg
5. Align the top rear hole in the front stabilizer leg
to the hole past the handle in the front of the
tongue (Figure
6. Install the long bolt through the holes and secure
it with a nut torqued to 102 N∙m (75 ft-lb); refer
to Figure 7.
Note:
The stabilizer leg pivots rearward on the
bolt. If you install the bolt into the wrong hole,
the stabilizer leg will not work properly.
7. Insert the clevis pin to lock the front stabilizer leg
in position (Figure
3

Installing the Safety Chain

Parts needed for this procedure:
1 Safety chain
2
Connecting link
Procedure
Form a hook on the end of a bendable piece of rod or
stiff wire (not included) and install the safety chain and
connecting links as shown in
Side-Dump Models
11
7).
7).
Figure 8 or Figure
Figure 8
9.
g035100