Table of Contents
Advertisement
Figure 25
Side-Dump Models
1. Connecting links
2. Keyholes in front post
Figure 26
End-Dump Models
1. Connecting links
2. Keyholes
3.
Connect each length of chain to the safety
chain mounting point on the tow vehicle with the
connecting links
(Figure
Important:
Ensure that the chain has
enough slack for turning around corners
when towing the machine.
Note:
For side-dump models, stow the excess
chain inside the bottom of the front post by
pushing it into the keyholes and latching the
appropriate links into the keyhole slots.
Note:
For end-dump models, connect the
connecting links to the appropriate links in the
safety chain
(Figure
hangs too low and touches the ground, connect
3. Chain crossed under tow
pole
3. Chain crossed under
tongue
4. Chain
27).
27). If the excess chain
it again to the connecting link to raise it away
from the ground.
g021177
1. Connecting link
2. Safety chain mounting
point on tow vehicle
Connecting and Checking the
Lights
Machines Equipped with a Light Kit Only
1.
Connect the electrical plug of the machine with
the electrical plug of the tow vehicle
g019928
Note:
The machine uses a standard 4-pin, flat
plug. If your tow vehicle has a different type
of plug, obtain an adapter from an automotive
parts store before towing.
2.
Ensure that the tow vehicle is in the N
position, engage the parking brake, and start
the engine.
3.
Test the lights as follows:
A.
Turn on the headlights of the tow vehicle.
The tail lights of the machine should
illuminate.
B.
Press the brake pedal of the tow vehicle.
The brake lights of the machine should
illuminate.
20
Figure 27
3. Chain link
4. Chain
(Figure
Figure 28
EUTRAL
g019927
28).
g020828
Advertisement
Table of Contents
