Configuration-Mode; Local And Remote Configuration; General Notes; Several Functions Only Apply To The Currently Selected Channel - ABB Uvisor SF910i User Manual

Integrated safeflame scanner

Table of Contents

8 Configuration-Mode

Configuration-Mode

In Configuration-Mode, the LCD menu provides installation-specific information about

the SF910i. Configuration settings can be changed using the four touch-buttons on the

display. A complete list of the Configuration-Mode functions and their default values are

found in

8.1

Local and Remote Configuration

There are several ways to configure the SF910i:

Locally by means of the display and touch-buttons (operating with open enclosure,

in non-hazardous area).

Locally (MODBUS) by means of a system (running Flame Explorer software)

connected with a short cable to one of the two serial channels of the SF910i

(operating with open enclosure, in non-hazardous area).

Remotely (MODBUS) by means of a system (running Flame Explorer software)

connected to the end of the communication network that, very likely, connects

together all the SF910i of the system. Full configuration capability.

The above

following explanations. They can be referred as MODBUS remote configuration.

8.2

Some notes on the Configuration-Mode are as follows:

8.2.1

To enter Configuration-Mode, hold the P pushbutton at the same time as the ▲

pushbutton (hold for five seconds). Use the ▼ or ▲ pushbuttons to scroll the curser up

or down the main menu.

8VZZ005286 B

Appendix

Step number 2

and

Step number 3

are considered equivalent for the

Table of Contents