Program-Mode; Notes For Program-Mode - ABB Uvisor SF910i User Manual

Integrated safeflame scanner

Table of Contents

9 Program-Mode

Program-Mode

Program menus provide specific Flame Scanner tuning values that define response

times and limits.

A complete list of the Program-Mode functions, their defaults, and available selections

are found in

9.1

Notes for Program-Mode

–

The values displayed or changed only apply to the currently selected Tuning

Function-Set. The Channel and Tuning Function-Set selected are displayed in the

upper right corner of the LCD display.

–

To enter Program-Mode, press the RIGHT pushbutton momentarily, followed by the

▼ touch-button within two seconds.

–

Exit the Program-Mode by holding in the d touch-button for two seconds. If there is

no activity for 20 seconds, the SF910i will automatically transfer to Normal-Mode.

–

The menu screens that the user see may vary depending on the configuration.

–

The user cannot directly pass from Program-Mode to Configuration-Mode or

vice-versa. The user must first go to Normal-Mode, then to Configuration-Mode.

–

Recommended initial settings for specific applications can be found in

–

Invalid input out of range as rules in

value is un-changed which can be verified through re-entering and double-checking.

The specific Program-Mode functions are described in the following sections in the order

of their appearance on the menu.

When the user adjust the tuning value through the ▲ touch-button and ▼

touch-button, press the LEFT pushbutton to cancel, and press the RIGHT pushbutton

to confirm that the set value is effective and save.

8VZZ005286 B

Appendix

Appendix K

will not be activated, and the last

Appendix

Table of Contents