Huawei V500R003C00 Maintenance Manual page 39

FusionModule2000 Smart Modular Data Center
Maintenance Guide
Table 4-10 Semiannual maintenance for the management system
Item
Check the
availability of
the smart ETH
gateway.
Check the
availability of
the rack
environment
unit.
Check the
availability of
the AC
actuator.
Issue 05 (2020-03-25)
Operation
On the ECC800
WebUI, choose
Monitoring >
System > Smart
ETH Gateway
Group > Smart
ETH Gateway to
enter the operating
information page,
and check the
communications,
PoE port
connection, and
power supply.
On the ECC800
WebUI, choose
Monitoring >
Cabinet > IT
Cabinet > Cabinet
Collector to enter
the operating
information page,
and check
information such as
communication
status and
temperature.
1. On the ECC800
WebUI, choose
Monitoring >
Aisle > AC
Actuator
Group > AC
Actuator >
Running
Parameters, set
Set light mode
to Manual, and
click Submit.
2. On the ECC800
WebUI, choose
Monitoring >
Aisle > AC
Actuator
Group > AC
Actuator to
enter the
Controls page,
Copyright © Huawei Technologies Co., Ltd.
Standard
On the ECC800
WebUI, check that the
PoE port connection
and power supply in
the smart ETH
gateway is normal.
The communication,
temperature, and door
status information of
the rack environment
unit are normally
displayed on the
ECC800 WebUI.
Lights in the smart
module aisle can be
normally controlled
through the AC
actuator.
4 Routine Maintenance
Troubleshooting
If the PoE port
connection and power
supply in the smart ETH
gateway is not normal,
check whether the
communications cable is
loose or disconnected. If
so, reconnect the cable.
If not, replace the smart
ETH gateway.
If the display is not
normal, check whether
the communications
cable is loose or
disconnected. If so,
reconnect the cable. If
not, replace the rack
environment unit.
If the lights cannot be
normally controlled,
check whether the AC
power cable to the lights
is loose or disconnected.
If so, reconnect the
cable. If not, replace the
AC actuator.
32