Table of Contents
Advertisement
FusionModule2000 Smart Modular Data Center
Maintenance Guide
2.
3.
Issue 05 (2020-03-25)
Figure 6-28 Removing a magnet
(Optional) Insert the positioning pins of the magnet into the magnet using a rubber mallet,
as shown in
Figure
6-29.
Figure 6-29 Installing positioning pins of a magnet
Insert the assembled magnet into the magnetic lock base on the revolving door, and
secure the magnet to the door using the screws on the door and the white rubber washer
delivered with the magnet, as shown in
When securing the magnet to the door panel, do not over-tighten the screws so that the white rubber
washer is elastic. The washer will adjust the magnet to a correct position because of its elasticity.
Copyright © Huawei Technologies Co., Ltd.
Figure
6-30.
6 Parts Replacement
77
Advertisement
Table of Contents
