Pioneer CDJ-2000NXS2 Service Manual page 38

1
7 Drive operation / error rate measurement
A
8 Auto standby check
B
C
D
E
F
38
1
2
This displays the state of the drive at the time of servo test and the measurement result
of the error rate.
Please refer to
"[7] Check mode of servo of the drive unit"
for details.
Auto standby usually starts when there are no media to reproduce and when operation is
not performed for a certain period of time.
In this mode, however, you can immediately switch to the auto standby mode.
To recover from auto standby mode, trigger any operation except the following:
performed,
• Press the USB STOP button
• Jog rotation (except for touching the Table top)
• Turn the TOUCH/BREAK , RELEASE/START volume
• Move the TEMPO slider
• Switch the DIRECTION lever
Auto standby mode will be reset.
Since auto standby reset is the same processing as turning the power on,
the service mode will be ended.
CDJ-2000NXS2
2
3
3
4
4